Thermorail S60SAB, Руководство по установке

Страница: 5 / 12

5
Electrical connection options
• Junction Box: If the electrical connection is to be inside a junction box, cut
the electrical cord down to 200mm from where it exits the metal wall disc
of the element cover.
•
Conduit from the wall: if the electrical connection is to be directly from a
conduit in the wall, cut the electrical cord down to 100mm from where it
exits the metal wall disc of the element cover.
The towel rail can now be placed over the
anchor bushes. To allow for easier
connection, secure only the top left-hand
side grub screw using the allan key until the
rail is held and cannot be pulled from the
wall
– this will allow for an easier electrical
connection at the bottom right-hand side of
the rail.
Push the electrical cord through the centres of the metal disc and plastic
plate (Fig.4). Connect the wiring and then attach the metal disc to the
junction box or wall using the fasteners provided. Only once the element
cover has been fastened, press the rail against the wall and tighten the grub
screws in each of the bracket tubes to secure the rail to the wall. Push the
cover plate over the metal disc and plastic plate.
Ensure you have 240Volt power at the connection point between you
Thermorail Heated Towel Rail and the mains supply. Once checked tick this on
page 9.
Fig.4
Installation Steps