Thermopatch Deco-Print DP2000T, Руководство пользователя

Страница: 25 / 48

thermopatch.com
25
Print head will not descend Touch guard activated
Temperature not ready
Solenoid air valve not shift-
ing
Air supply not connected
Foot switch is unplugged or
bad
Leak or restriction in air line
or connections
Press Clear
Wait
Replace
Check
Check/Replace
Check/Repair
Print head too slow or fast Flow control(s) adjustment is
incorrect
Mechanical blocking
See pg.39 item 14
Check & Correct
Timed print cycle does not
activate
Garment or cloth is too thick
Leak in hose or connections
Defective microswitch
Mechanical binding
Check
Repair/Replace
Replace
Check & Correct
Print Head does not rise to
the open position
Air solenoid valve not shift-
ing
Leak or restriction in air line
connections
Mechanical binding
Check/Replace
Check/Repair
Check & Correct
Overall print is
too light
Air pressure is too low
Temperature is too low
Time setting is too low
See pg 19
See pg 23
See pg 23
Parts of design are not print-
ed
In ribbon feed not working
properly
Rubber print platen is dirty
or worn
In ribbon to properly guided
left to right
Overlap of printed impres-
sions in used ink ribbon
Ink ribbon not wide enough
One corner of rubber platen
needs adjustment
Check threading per pg 15
Clean or replace
Check ink ribbon threading
Adjust longer, see pg 24
Use wider ribbon
See pg 22
Center of “O”, “A”, etc is
filled with ink; imprint is un -
clear
Temperature is too low
Time setting is too low
Engraved plate is dirty
Pressure incorrect
See pg 23
See pg 23
Clean
Clean & Correct
When type slugs are used,
print is unclear
Type slugs are dirty
Deformed type slugs caused
by high heat
Pressure incorrect
Clean
Adjust heat per pg 20; re-
place slugs
Check & Correct
Ink marks on back side of
garment
Ink build-up on rubber plat-
en
Clean Platen. See pg 45
Emergency stop push button
will not operate
Push button is defective Replace, see pg 38