3
1a.
For one or two cables. Locate bus connection
(HPT and FP only) and cable as shown. Cut end
of cable at angle to aid in piercing grommet.
Leave additional cable for expansion loop.
2a.
For one or two cables. Insert cable into
expediter. If mounted on bottom of pipe, punch
out weep hole.
1b.
Two cables.
3.
Slide expediter toward pipe and route cable
through support base entry.
4.
Insert banding guide into expediter and snap
into place.
5.
Mount expediter to pipe using pipe band. Do
not band over cable.
2b.
Two cables.
INSTALLATION PROCEDURES
