Software description SRC-ADO
Thermokon Sensortechnik GmbH
Page 17
4 Configuration of Outputs
By actuating the button “Configure output“
the window for the configuration of the
outputs is opened. It consists of the rider “Property” for adjusting different properties and
the rider “Sensors” for learning-in and assigning sensors to the outputs (picture 4-1).
4.1 Register Card Property
The register card property is designed for the parameterizing of the output. Type and
number of property is depending on the output functions selected. For instance, picture 4-1
shows the setting adjustments for the function “sensor-temperature”. The detailed
description of all properties is made later on.
Property changes are transmitted by pressing the “OK“-button or by the “Take over“
button.
Picture 4-1: Sensor – Temperature
Independent of the output function selected, the configuration window always disposes of
the following setting options:
4.1.1 Sensor Monitoring
If a sensor fails, a defined value can be assigned to the output. The same is adjustable via
the field “
upon sensor failure
”. The monitoring time of a sensor amounts to 90 min. If a
sensor is transmitting again after a failure, the output is operating properly again.
4.1.2 Reading of Output
In the field
“Reading“
the current status of the output can be displayed by activating the
hook mark.
4.1.3 Scaling of Output Quantity
The analogue output can be adjusted in the field
“lower and upper output voltage“
of 0-
10 V.
