ThermoFisher Scientific HERASAFE 2025, Руководство по эксплуатации

Страница: 35 / 76

HERAsafe 2025 50161258 | 35
Start-up |
Chapter 5
2. To attach the device frame [5] to the stand [7], install four Allen screws [6] loosely
into the corresponding threaded holes at the underside of the device.
3. Place the safety cabinet onto the stand so that the Allen screws [6] pass through the
corresponding holes [8] of the retaining tabs [10].
4. Push the device frame [5] in the grooves [9] of the retaining tabs [10] all the way to
the stop.
5. Tighten the four Allen screws [6].
Leveling the Device
The cabinet should be levelled only after it has been positioned.
1. Remove transport protection (foil) from the workplate or from the workplate segments.
2. Lift the workplate or the workplate segments and place it/them onto the front and
rear rails in the sample chamber with the wide line of holes facing forward.
3. Device without stand: Place a bubble level onto the workplate and align the
substructure until the bubble level indicates an exactly horizontal position in all
directions.
4. Device with a stand: Place a bubble level onto the workplate and use the four
levellers to effect a level state in all planes.
When adjusting the device stand height, proceed from right to left and from rear to front.