THERMOFILM AUSTRALIA 27 Rosalie Street, Springvale VIC 3171
Ph: 03 9562 3455 Fx: 03 9548 3979 www.thermofilm.com.au
E L E X
e u r o
C
O
N
V
E
C
T
I
V
E
P
A
N
E
L
H
E
A
T
E
R
S
•
In the immediate vicinity of pipes or containers which carry or contain combustible or
potentially explosive substances.
For this reason, the minimum clearance intervals must not be undercut.
In workshops or other areas in which the odor of waste gases, oil, petrol, etc. might occur, or in
which work is carried out involving solvents and chemicals, there is a risk of sustained odor burdens
being engendered, and possibly of dirt contamination occurring.
Before using any materials which produce flammable gases or vapors, e. g. laying or sealing parquet or
PVC flooring, or when using spray polishes, spirits and similar materials, ensure the heater is switched
off.
3.5 Maintenance
Do not use abrasive or aggressive cleansers to clean the heater. Use a vacuum cleaner regularly to
clean the upper and lower air grids.
4. Installation instructions
The
ELEX
euro
convective panel heaters
are electric heaters designed to be mounted on the
wall or freestanding using the supplied castor wheel set. These units are suitable for heating
enclosed indoor rooms such as bedrooms, studies, offices, living areas and bathrooms.
ATTENTION!
The installation, electrical connection and first operation of this appliance should be
carried out by a qualified installer. The company does not accept liability for failure of any
goods supplied which have not been installed and operated in accordance with the
manufacturer's instructions.
These installation instructions belong with the heater and must be handed on to the purchaser if the
heater is sold.
4.1
Installation Location
The ELEX
euro
convective panel heater was designed to be installed in a residence. Please ask your
distributor before using it for any other purpose.
The ELEX
euro
convective panel heater should be installed according to normal trade practice and
in compliance with legislation in relevant country.
The panel convector is
CLASS I
and is protected
against splashed water (IP24). Therefore it can be
installed outside the shaded area shown in the bathroom
area
Ensure the safety zones (mm) in diagram (left
hand side) are kept free.
If the wall covering is laid on foam, a spacer the same thickness as the foam must be placed under the
panel heater’s support. This ensures there is free space behind the panel heater to make sure its
control settings are not adversely affected.
