Thermo Scientific Neslab Dimax, Руководство пользователя

Страница: 21 / 30

- 19 -
Remote Interface
The temperature of the cooling fluid and the status of the low flow and low fluid
detectors can be monitored by an external device using the monitor receptacle
located on the control panel.
Pin #1 Flow monitor output (return #1), active if flow is satisfactory sink current.
Pin #2 Flow monitor output (return #2), active if flow is satisfactory sink current.
Pin #3 Flow monitor output (return #3), active if flow is satisfactory sink current.
Pin #4 Flow monitor output (return #4), active if flow is satisfactory sink current.
Pin #5 Flow monitor output (return #5), active if flow is satisfactory sink current.
Pin #6 Customer supplied 24VDC power supply to unit (+).
Pin #7 Customer supplied 24VDC supply common.
Pin #8 Customer su15VDC supply to unit (+).
Pin #9 Customer supplied ±15VDC common.
Pin #10 Customer supplied -15VDC supply to unit (-).
Pin #11 Temperature signal output (+). The temperature scale is 100mVDC/°C.
Pin #12 Analog signal output common (-).
Pin #13 Low fluid level monitor output, active if level is satisfactory sink current..
Pin #14 24VDC common output. Common connection for flow switches and low fluid level safeties.
Pin #15 Flow monitor output (return #6), active if flow is satisfactory sink current.
Pin #16 Flow monitor output (return #7), active if flow is satisfactory sink current.
Pin #17 Flow monitor output (return #8), active if flow is satisfactory sink current.
Pin #18 DI water resistivity output (1V/meg-ohn) , active if flow is satisfactory sink current.
Pin #19 Cartridge good/bad output, active if resistivity is above low resistivity setpoint.
Pin #20 Flow monitor output (facility water), active if flow is satisfactory sink current.
Flow monitors, low fluid level monitor, and cartridge monitor connections are
active (current sink to pin 14) when respective conditions are satisfactory, and
open when conditions are unsatisfactory (or when unit is off).
The temperature signal circuit has a differential output. Pin 12 must be
connected to ground in the monitoring system. This signal is only available if
the unit is on and 24VDC and ±15VDC is supplied to this connector.
Monitor receptacle