Thermo Scientific Multifuge X1R, Инструкция по эксплуатации

Страница: 27 / 58

4
Operation
Entering parameters
Thermo Scientific
Multifuge X1R
4-7
SAMPLE
When SAMPLE is lit, the temperature of the sample will be controlled.
To set the temperature, proceed as follows:
1. Press the key in order to open the temperature selection menu.
Prewarming or precooling the centrifuge
For setting the pretemp value for the centrifuge proceed as follows:
Hold down the
The display shows the message
Set PreTemp
.
4. The display shows:
The display shows the messages
Temperature
. Depending on the display mode setting, the value
shown corresponds either to the sample temperature or to the inside chamber temperature. Press
the key to toggle between the two modes.
2. Enter the desired temperature using the numeric pad.
The digits show in sequential order.
3. Confirm your entry by pressing .
Your entry will be automatically confirmed if you do not press any key for 5 seconds.
1. key for a minimum of three seconds to open the temperature selection menu.
2. Enter the desired temperature using the numeric pad.
The digits show in sequential order.
3. Confirm your entry by pressing .
Your entry will be automatically confirmed if you do not press any key for 5 seconds.