Thermo Scientific Dionex ICS-5000, Руководство оператора

Страница: 362 / 482

Dionex ICS-5000 Operator’s Manual
346
Doc. 065342-06 12/11
2. Verify that a plug is installed in the vent port. This will prevent leakage
from the vent opening when you turn over the cartridge.
3. Turn the cartridge upside down and place it on the EG drip tray in the
service position (see Figure 9-17 ).
4. Remove the plugs from the
INLET
and
OUTLET
fittings on the eluent
generation chamber.
5. Connect the
EGC IN
line from the pump to the EGC
INLET
port.
6. Locate the yellow 0.5 mL/min, 7 MPa (1000 psi) backpressure coil
(P/N 053765) in the EG Ship Kit (P/N 072047).
7. Connect one end of the
backpressure coil to the EGC
OUTLET
port (see Figure 9-23 );
leave the other end of the coil
unconnected. This is a
temporary connection.
Figure 9-23. Analytical EGC Outlet Connection
for Conditioning Procedure
8. While holding the EGC right-side up (with the electrolyte reservoir on
top), shake the cartridge vigorously and tap it with the palm of your hand
10 to 15 times. Make sure any bubbles trapped in the eluent generation
chamber are dislodged.
Backpressure
EGC
Port
Outlet
Coil