2 | Preface
Pretreatment system
This information is valid for the system that is received. For
quick and correct service, include the following information on
all inquiries and replacement parts orders which relate to your
system:
•
The serial number (located on the right side of the system
on the nameplate)
•
The catalog number
Safety Precautions
Observe these safety precautions for your own safety!
•
Do not install or operate the system until you have
carefully read through these operating instructions and
the notes and notices contained therein.
•
Lifting and carrying the Pretreatment system, e.g. to the
installation location, can be carried out by one person. To
do this, lift the system at the two corner points beneath
the bottom plate.
•
Always observe the applicable, pertinent codes and
regulations valid at the installation location of the system
and follow all applicable accident prevention regulations.
•
If the system is not to be operated for an extended
period, e.g., over extended weekend, or during a
vacation period, close the feed-water inlet (close the
feed-water tap)
•
When installing the pretreatment system, always ensure
that there is adequate space all around the system (refer
to the table “Accessibility to Pretreatment system” in
section
Technical Specifications
) to ensure that ease
of use or easy replacement of materials (e.g., filter
change, connection) is possible at all times.
•
Visually inspect the system at regular intervals. Clean up
any water or spills found around the system immediately.
This symbol indicates a need to wear protective
goggles gloves during the indicated procedures.
This symbol indicates a situation in which
breathing protection must be used.
Note:
Is used for application hints and useful information.
CAUTION:
The Thermo Scientific Barnstead
Pretreatment system is a modern water
purification system intended solely for the
treatment of potable water. The water it produces
is not fit for drinking.
CAUTION:
To avoid the risk of pinching, crushing,
cutting, never perform maintenance on the system
without its protective housing, or while it is in
operation. Maintenance work on the system may
only be performed by trained, authorized
specialists.
