Thermo Scientific 11174729, Инструкция по эксплуатации

Страница: 11 / 66

Chapter 2
INSTALLATION PROCEDURE
Thermo Fisher Scientific MR23i 2-3
During rotation, the slightest leak from a sample is enough to
create an aerosol. Rotation of the rotor can only be detected when
the machine is switched on.
Opening the lid manually if the rotor is still rotating, would disperse
the aerosol in the environment.
Rotating parts are also a risk as these could come in contact with
the user or be ejected. There is
particularly high risk of injury if:
• The user tries to manually stop the rotor,
• Any object falls inside the centrifugation chamber.
Manual lid opening procedure:
Manual lid unlocking must only be done by someone informed of
the danger and of the necessary precautions to be undertaken.
If the machine has stoppped because of a mains power cut, the
rotor could still be rotating. Wait 10 minutes before opening the lid.
In spite of the absence of noise, the rotor could still be rotating
when you need to open the lid manually.
Even in the case of a mains power cut, always set the mains switch
to the OFF position before carrying out this operation.
• Lift up the rubber mat.
• Insert the unlocking device into the hole on the top right of the
instrument by piercing the protection sticker.
• While pressing down on the unlocking device, pull the lid lever
forward.
• The lid opens upwards automatically.
The protection sticker must be replaced after it has been pierced.
Figure 2-2.
Lid unlocking