Thermo Forma 916, Руководство по эксплуатации и техническому обслуживанию

Страница: 6 / 39

Model 916/917______________________________________________________________________________Installation
1-1
Section 1 - Installation and Start-Up
1.1 Unloading and Moving the Freezer
To remove the freezer from the pallet, use the 7/16"
wrench to remove all the bolts securing the shipping bracket to
the pallet.
Remove the shipping bracket. Remove the ramp boards from the
pallet and place the slotted end over the ramp brackets on the
pallet. The support blocks on the ramps will be facing down.
Before moving the freezer, make sure the casters are unlocked
and moving freely. Align the caster with the ramp boards. Use
adequate personnel to roll the freezer off the pallet.
The freezer can be easily pushed to the desired
approved location, described in Section 1.6. If necessary, the
doorstop may be removed to allow the door to swing fully open
to move the unit through tight openings. When the freezer is in
position, set the front caster brakes.
If tipped more than 45°, allow the unit to set
upright for 24 hours before start up.
The freezer must not be moved with the prod-
uct load inside.
1.2 Getting to Know Your Freezer
Figure 1-1, Control Panel
A
LED display - Shows actual chamber temperature and indi-
cates the control temperature set point when the Press-To-Set
button is pressed.
B
Condenser Hot indicator - Lights when the thermostat on the
condenser reaches approximately 40°C, indicating typically a
dirty air filter, a clogged condenser, a fan failure or high ambient
temperature.
C
Set Point Adjustment screw - Used to set the control temper-
ature set point.
D
Press-To-Set button - Press to display control temperature set
point.
E
Normal/Standby switch - Silences the audible alarm.
F
Low Battery indicator - Flashes when the battery needs to be
replaced.
G
Over Temp indicator - Flashes when the chamber tempera-
ture rises above the Over Temperature Alarm setting.
H
Voltage Compensation indicator - Indicates when the in-
coming electrical power is being automatically adjusted to
ensure that the compressor operates within specification.