Thermo Electron Ramsey ORETRONIC III, Руководство по эксплуатации и обслуживанию

Страница: 107 / 143

ORET RONIC
™
Tramp Metal Detector
R E C 4 1 0 5 A - 7
REGISTER
ADDRESS
ACCESS TYPE DESCRIPTION
LSB = ASCII code for character 7 (right most
character) of the text display
40028 Read Only P THERMO ELECTRON USE ONLY
40029 Read Only P THERMO ELECTRON USE ONLY
40030 Read Only P THERMO ELECTRON USE ONLY
40046 Read Only P Second general purpose status register, which is
used for diagnostic purposes.
If set (1), the bits have the following meanings
(otherwise, bits are 0):
Bit 0 - Remote mode is enabled
Bit 1 - Modbus is enabled
Bit 2 - T MD is in Setup/Calibration mode
Bit 3 - Speed input is enabled
Bit 4 - SYNC input is enabled
Bit 5 - Belt direction is set to “Reversed”
Bit 6 - Measure units are Metric
Bits 7–15 - Unused
40047–4009 9 Not used
40100 Read Only THERMO ELECTRON USE ONLY
40101 Read Only THERMO ELECTRON USE ONLY
40031 Read Only P General-purpose status register , which is used for
diagnostic purposes.
If set (1), the bits have the following meanings
(otherwise, bits are 0):
Bit 0 - NO RMAL LED is on
Bit 1 - AL ARM LED is on
Bit 2 - CALIB LED is on
Bit 3 - BYPASS LED is on
Bit 5 - Metal has been detected
Bit 6 - An error has been detected
Bit 7 - E1 error flag (Cold Start) is present
Bit 8 - E2 error flag (Reset Disable) is present
Bit 9 - F 1 fault flag (T ransmitter Coil) is present
Bit 10 - F 2 fault flag (Self T est) is present
Bit 11 - F 3 fault flag (Coil Balance) is present
Bit 12 - F 4 fault flag (High Pile) is present
Bit 13 - F 5 fault flag (A/D Converter Overload) is
present
Bit 14 - F 6 fault f la g (Audit Check Failure) is