thermital COROLLA PACK 1000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 29 / 40

29
Use and adjustment
8.4 User’s parameter change
From “Functioning values display” the following users’ parameters can be modified:

Setpoint high temperature circuit;

Setpoint sanitary circuit;

Setpoint low temperature circuit.
By pressing key S3 on the values display are shown respectively:

T_Flow System High. (pos.1);

T_dhw (pos.2);
 T_Flow System Low. (pos.4).
on the values display are shown respectively:
Press S2
:according to the relative functioning value. The set point value will flash on the last
two digits
If the value does not need to be changed, press S2 (SET/ESC) to return the display mode. If the value
needs to be modified, press S4 (+) and S5 (-) until the desired value will be displayed. Press S6
(Progr./OK) to store the value. Said value will stop lashing and after 3 seconded the display mode will
be restored.
In the following table is shown the procedure to change the setpoint of the low temperature circuit
from 50° to 40° C.
PROCEDURE DISPLAY
1 E.g. installation running with T_flow_system_high at 80
°
C
2
Press S3 (arrow), to access into the display mode, press again till the value detected from
T_flow_system_low is displayed (e.g. fig.8, 50
°
C)
3
Press S2 (Set/esc)
4
Premere S5 (-)till the set point returns to 40
°
C
5 Premere S6 (Progr/OK) to store the value.
6 After 3 sec. the display returns to the parameters display mode and the T6 is displayed
If no procedures are carried out for 10 seconds after that S2 (SET/ESC) has been pressed (to modify
the set point of the corresponding parameters to the one displayed), the boards returns to “functioning
values display” mode
If after pr or – the buttons aren’t used for a period of one minute the display also returns to
“functioning values display” mode. When this happened the new setting will not be stored .