thermital COROLLA PACK 1000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 28 / 40

28
Use and adjustment
8.2 Display during normal operation
The red led, D5, is turned on in case of anomalies which imply the permanent block-out on any unit
(only the Mater or Slave reset button will restore normal functioning).
The green led, D4, shows power on. The three 7 segment displays shall visualize:
SYSTEM STATUS DISPLAY
No demand from the heating and sanitary circuit
(figures on the right display the T1 e.g. T1 = 30°C
Demand from circuit N°1 or simultaneous functioning the 1° and 2°.
(figures on the right display the T1 e.g. T1=80°C)
Demand from sanitary circuit or simultaneous functioning.
(figures on the right display the T1 e.g. T1=80°C) the dot after the first figure must be flashing
Demand from 2° circuit
(figures on the right display the T1 e.g. T1=80°C)
Antifreeze function is active or external probe is disconnected (see also Par. 6.2.7)
8.3 Function values display
Press S3 (arrow) to step forward from functioning display and to visualize the following value (below
listed values shall be displayed in succession by pressing the S3 button).
POS. DISPLAYED VALUES DISPLAY
1 Flow Temperature High T1 (e.g. T1=80°C)
2 Sanitary Temperature T3
3 Outdoor temperature T4
4 Flow Temperature Low T6
5
1° circuit room thermostat open or close
(e.g. Ta1 close -
oF
- ; Ta1 open -
on
)
6
2° circuit room thermostat open or close
(e.g. Ta2 close -
oF
- ; Ta2 open -
on
)
7
Analogical Input 0-10V
(e.g.. 5.5V; 10V )
8
Mixing valve status
e.g. close
9 Main pump status (e.g. pump not functioning; e.g. pump functioning)
10 Sanitary circuit pump status (e.g. pump not functioning; e.g. pump functioning)
11 Secondary pump status (e.g. pump not functioning; e.g. pump functioning)