THERMEx Water filter, Инструкция по установке и эксплуатации

Страница: 24 / 28

English
24
3. Shut off the mainstopcock or the stop valve on the inlet pressure relief valve.
4. In order to release the pressure in the heater, the boiling water tap needs to be opened again. Turn it off
again once the water stops flowing.
5. In the case of an existing installation, always replace the connection kit with a new one.
Installation of the filter system
1. Determine the location for the filter. The filter should be attached to the
rear or side wall of the kitchen cupboard. Make sure that there is enough
space for the filter components to be installed
(see steps 2 and 3) and that the filter can be changed during
maintenance.
2. For a correct installation of the filter, use the template that comes with
the installation manual of the filter system.
3. Attach the supplied hose between the left side of the filter bracket
and the T-connector. Use PTFE-tape/Teflon to prevent leakage.
! Attention! Note the direction of water flow through the water
filter
Attach transitionconnector on right side of filter. Use PTFE-tape/ Teflon
to prevent leakage.
4. Install the connection kit with the copper tube (15 mm) to the filter
bracket.
The filter is now connected. Proceed to step 3 of the boiling water
heater manual.