THERMEx Water filter, Инструкция по установке и эксплуатации

Страница: 23 / 28

English
23
Introduction
With this water filter, your water is purified first before you draw it from the tap. You need to install the filter
between your mains cold water inlet and your connection kit. The installation of the boiling water vessel
remains unchanged.
This installation and user instructions gives you the correct instructions for fitting correctly, and safely using
the filter. If the filter is not installed and connected according the instructions the warranty will be void.
The manufacturer is not liable for damages resulting from an incorrect assembly or skills resulting from the
incorrect compliance with the regulations.
Package contents
1. Check the contents of the package.
1x Norit Filtrix filter
1x Norit Filtrix connection bracket
1x Transition connection 15mm
1x Flex Hose 3/8” x compression 15
Installation
Instructions
1. The filter is only suitable for installation in the mains cold water supply. The maximum temperature of the
incoming water is 40ºC.
2. Install the filter before the connection kit.
3. The maximum mains pressure before the filter must never exceed 6 bar. Consult your supplier for
information on mains current water pressure.
4. If the filter is installed and connected to a water supply that is already in use, make sure that the
installation is thoroughly flushed. Protect your installation against frost.
5. Treat the filter system carefully and do not expose the filter itself to shocks.
6. Consult your local regulations for water installations. Follow these regulations when installing the filter
system.
For existing installations
1. Always first remove the mains lead from the fused spur.
2. Open the boiling water tap until only cold water flows from it.