Thermal AXAI-06M, Руководство по установке

Страница: 7 / 21

6
•
Ensure the units are securely installed.
If the unit is insufficiently secured or installed, the unit could fall causing injury. The minimum
support weight of 20g/mm² of the installation is required. When installing the unit in an
enclosed area or a confined space please consider the room measurements and sufficient
ventilation to prevent the asphyxia caused by the leakage of refrigerant.
•
Use the specified electrical wires and attach the wires firmly to the terminal
board (connection in such a way that the stress of the wires is not applied to the
sections).
Incorrect connection and fixing could cause a fire.
•
Be sure to use the correct or specified materials for the installation work. The
use of defective parts / materials could cause an injury due to possible fire, electric
shocks, the unit falling etc.
•
Perform the installation securely and please refer to the installation
instructions.
Incorrect installation could cause an injury due to possible fire, electric shocks, the unit
falling, leakage of water etc.
•
Perform electrical work according to the installation manual and be sure to use
a dedicated section.
If the capacity of the power circuit is insufficient or there is an incomplete electrical circuit, it
could result in a fire or an electric shock.
•
The unit must always have an earthed connection.
If the power supply is not earthed, you may not connect the unit.
•
Do not attempt move/repair the unit yourself if you are not a LCP installer.
Improper movement or repair on the unit could lead to water leakage, electrical shock,
injury or fire. Have any repairs and/or maintenance only carried out by a recognized
service engineer.
•
Do not plug or unplug the power supply during operation
There is a risk of fire or an electric shock
•
Do not touch/operate the unit with wet hands
There is a risk of fire or an electric shock
•
Do not place a heater or other appliances near the power cable
There is a risk of fire or an electric shock
Be cautious that water could not be poured to the product directly, do not allow
water to run into electric parts
There is a risk of fire or an electric shock
IF THE PRODUCT IS NOT USED FOR LONG PERIODS OF TIME, WE STRONGLY
RECOMMEND NOT TO SWITCH ‘OFF’ THE POWER SUPPLY TO THE PRODUCT.
IF THE POWER IS NOT SUPPLIED, SOME OF THE PRODUCT-PROTECTING
ACTIONS (SUCH AS WATER PUMP ANTI-LOCKING & CRANK CASE HEATER)
WILL NOT BE OPPERATIONAL