It is the customer’s responsibility to:
•
Contact a qualified electrical installer.
•
Assure that the electrical installation is adequate and in
accordance with National Electrical Code, NNSI/NFPA 70-
latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
LCDI Plug and Power Cord
To test your LCDI Power Cord
NOTE:
Your unit’s device may differ from the ones shown.
1. Plug power supply cord into a grounded 3 prong outlet.
2.
Press
RESET.
3.
Press
TEST
(Listen
for
a click; Reset button will trip and pop out).
4. Press and release RESET (Listen for a click; Reset button will
Latch and remain in). The power supply cord is ready for operation.
NOTES:
•
The reset button must be pushed for proper operation
•
The power supply cord must be replaced if it fails to
trip when the test button is pressed of fails to reset
•
Do not use the power supply cord as an off/on switch.
The power supply cord is designed as a protective
device.
•
A damaged power supply cord must be replaced with
a new power supply cord obtained from the product
manufacturer and must not be repaired.
•
The power supply cord contains no user serviceable
parts. Opening the tamper-resistant case voids all
warranty and performance claims.
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense leakage current. If the cord is crushed, the
electronics detect leakage current, and power will be
disconnected in a fraction of a second.
950-0077-revD Page 5 of 16 9 May 2007
