Thermal Dynamics PakMaster 75XL Plus, Руководство по эксплуатации

Страница: 27 / 48

Manual 0-2746 4-1 OPERATION
SECTION 4:
OPERATION
4.01 Introduction
This Section provides a description of the Power Supply
operating controls and procedures. Identification of the
Front and Rear Panel components is followed by operat-
ing procedures.
4.02 Operating Controls
This subsection provides specific functional descriptions
of the Power Supply operating controls and indicators.
A. Front and Side Panel Components
1. Control Panel
All operator controls, except gas pressure adjustment,
are located on this panel. Power ON / OFF and RUN
/ SET / LATCH switches; CURRENT control; indi-
cators for AC Power, TEMP, GAS, and DC.
A-02458
1
2
3
4
5
Figure 4-1 Front and Side Panel Connections
2. Access Panel
A panel for access to the bulkhead area containing
the torch connections.
3. Torch Leads Input
Hole in the front panel to feed the torch leads through
to the internal bulkhead connections.
4. Work Cable and Clamp
Work cable with clamp (factory installed).
5. Torch Leads and Spare Parts Kit Storage Area
Bracket connected to the side panel of the unit for
use in storing the torch, torch leads, work cable, and
spare parts kit when not in use. The spare parts kit
fits into the opening on the top of the bracket. The
torch leads and work cable wrap around the bracket
for easy storage.
B. Control Panel Components
A
A-03625
15
40
60
1
2
3
4
5
6
7
Figure 4-2 Operating Controls
1. Current Control (A)
Adjustment to set the desired output current between
15 - 60 amps. For drag cutting applications set the
control between 15 - 35 amps. The unit has an auto-
matic fold - back circuit that limits current to 35 amps
during drag cutting.
2. ON / OFF Power Switch
ON position supplies AC power to activate all sys-
tem control circuits. OFF position deactivates con-
trol circuits.
3. RUN / SET / LATCH
Switch
RUN position is used for torch operation. SET posi-
tion used for setting gas pressure and purging lines.
LATCH position is used for specific applications
(torch switch can be released after main arc transfer).
4. AC Power Indicator
Green indicator will blink ON then OFF for approxi-
mately eight seconds and then stay ON after the ON
/ OFF power switch is set to ON. Indicates operat-
ing power is present in the unit.