Page 11
Installing an Integral
Installing an Integral
Installing an Integral
Installing an Integral
Installing an Integral
Blower:
Blower:
Blower:
Blower:
Blower:
The PHE hood can be in-
stalled with Thermador’s
VTN1000Q blower.
1. In the 30” PHE model
remove the two spacers
A
A
A
A
A
shown in Figure 12. Each
spacer is held in place by
three screws.
Figure 12
2. For horizontal discharge
install four M5 screws in
location
B
B
B
B
B
as shown in
Figure 12. Install the
screws in the hood top plate
for vertical discharge instal-
lations. Do not tighten
screws.
3. The four screws in step
two are used to mount the
motor by guiding the screws
into the slots on the motor
mounting plate. Tighten the
screws
B
B
B
B
B
.
W
W
W
W
Wiring the PHE with an
iring the PHE with an
iring the PHE with an
iring the PHE with an
iring the PHE with an
Integral motor:
Integral motor:
Integral motor:
Integral motor:
Integral motor:
W
W
W
W
War
ar
ar
ar
arning: Tur
ning: Tur
ning: Tur
ning: Tur
ning: Turn of
n of
n of
n of
n off elec-
f elec-
f elec-
f elec-
f elec-
tricity at the service
tricity at the service
tricity at the service
tricity at the service
tricity at the service
panel befor
panel befor
panel befor
panel befor
panel before wiring the
e wiring the
e wiring the
e wiring the
e wiring the
unit.
unit.
unit.
unit.
unit.
1. Connect the VTN1000Q
molex plug connector to the
connector present inside
the hood as shown in Fig-
ure 13.
2. Remove the j-box cover
as shown in Figure 14.
3. Remove 1 of 2
knockouts and install 1/2”
conduit connector in j-box.
Figure 13
4. Run black, white, and
green wires (#16 AWG) in
1/2” conduit from power
supply to j-box.
5. Connect black, white,
and green wires from power
supply to black, white, and
green/yellow wires in j-box
respectively.
