Installation Instructions
English | 7 |
Advance Planning
Before You Begin
CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Parts Included
Hood assembly (LED lamps already
installed)
Blower housing
Top and lower duct covers
Structure horizontal supports
Structure upper/lower
vertical supports
Grease ilters
Fastener assortment*
* Hardware provided is for mounting through standard
thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of
mounting situations.
NOTE:
Carefully remove the protective ilm from the duct
cover and hood assembly prior to the start of the installa-
tion. Use one hand to maintain the assembly/duct cover
steady while the other hand removes the protective ilm.
Tools and Parts Needed
•
Ducting as needed (refer to Equivalent Duct Lengths
for Commonly Used Transitions Table)
•
Aluminum tape (DO NOT use duct tape)
•
1/2’’ (13 mm) Conduit if required (follow local codes)
•
1’’ (25.4 mm) Strain relief
•
Ducting as needed
•
Blower
•
Flat head and Phillips screwdrivers
•
Drill with
3
⁄
16
’’ (4.76 mm) drill bit
•
Circular saw or jigsaw
•
3/8’’ (9.52 mm) nut driver or socket and ratchet
•
Wire stripper
•
Protective work gloves
IMPORTANT: DO NOT
throw away any packaging until
appliance is fully installed.
Optional accessories available for separate
purchase.
Refer to www.thermador.com for more details.
•
CHXTHMIB – Telescopic Duct Cover Extension Kit
•
RECHMIB – Recirculating Kit
•
CHFHMCD – Charcoal Filter Replacement Kit
•
REMCPW – Built-In Remote Control Accessory
