Thermablaster WLT060-VF, Руководство пользователя

Страница: 11 / 34

11
CAUTION: This heater creates warm air currents. These
currents move heat to wall surfaces next to heater.
Installing heater next to vinyl or cloth wall coverings or
operating heater where impurities (such as tobacco smoke,
aromatic candles, cleaning fluids, oil or kerosene lamps, etc.)
in the air exist, may cause walls to discolor.
IMPORTANT: Vent-free heaters add moisture to the air.
Although this is beneficial, installing heater in rooms without
enough ventilation air may cause mildew to form too much
moisture. See Air for Combustion and Ventilation.
Figure 4 -
Mounting clearances
from combustibles as
viewed from front of heater (inches)
Check Gas Type
Be sure your gas supply is right for your heater. Otherwise, call dealer where you bought the heater from
for proper type heater.
Clearances to Combustibles
Carefully follow the instructions below. This heater is a freestanding unit designed to be mounted on a wall.
WARNING: Maintain the minimum clearances shown in Figure 4. If you can, provide greater
clearances from floor, ceiling, and joining wall.
LOCATING HEATER
This heater is designed to be mounted on a wall. For convenience and efficiency, install heater:
1) where there is easy access for operation,
inspection, and service.
2) In the coldest part of room.
MOUNTING HEATER TO WALL
1 . Mounting the Bracket
Mounting the attached bracket with folding anchor on desired location
2. Hanging the heater on the bracket, simply finished.
Figure 5 - Mounting holes Location
Figure 6 Mounting on wall 060/100-VF Figure 7 Mounting on wall 320-VF