8
FOR YOUR SAFETY
1.
Electrical and/or Light Receptacles shall not be installed inside the TheraSauna®
room.
2.
Do not add any locking or latching systems to the door of your TheraSauna®.
Malfunction of which could cause entrapment inside the sauna.
3.
The TheraSauna® comes with a sliding roof vent to provide proper ventilation to
allow in fresh air if so desired. Keep vent closed when heating sauna.
ASSEMBLY TIPS
All assembly instructions are included with your TheraSauna®. The following are
tips for safely and correctly assembling your TheraSauna®:
1.
When picking up the side panels or roof, do not pick them up along the thin
trim pieces as they may crack. Also, when putting the walls together, be gentle
and do not push too hard on these trim pieces.
2.
When assembling the walls, do not over tighten the bolts until after you put the
seat panel in place. By leaving the bolts and side panels a little loose, you can
put the bench support panel and seat panel in without scraping the inside walls
of the side panels. Once the seat is in place, you can snugly tighten all bolts.
3.
If you need to move an assembled sauna, you should only push against the
bottom floor section of the TheraSauna®. Do not push against the sidewalls.
4.
Install tulip light as desired, with glass shade facing up or down. When
considering your choice for a light bulb for your new TheraSauna®, keep in
mind that the light bulb operates on a dimmer-controlled switch. A standard 60
watt incandescent bulb is the recommended style or an incandescent bulb that is
designed to be used with a dimmer switch (such as a touch lamp, 3-way style).
We do not suggest using a compact fluorescent bulb as they do not operate
correctly with a dimmer and may cause damage to your sauna’s light control
switch. See manufacturer’s warning on the fluorescent bulb package, “
Not
intended for use with electronic timers, photo cells, or with dimmers.”
