12
START UP/PANEL ADJUSTMENTS
Note: If you experience power failure, sauna will return to factory default settings,
which are 135 F and 60 minutes, you will have to reset your settings. On powering
up the sauna the panel will display sauna internal temperature.
Once the TheraSauna® reaches the set temperature, the heat indicator light will turn
off letting you know the sauna has reached your desired temperature. This does not
mean that the sauna is no longer emitting infrared. At this time, our patented,
StableHeat system will work its magic. The onboard computer will reduce the voltage
going to the TheraMitters™ to keep them on and emitting infrared, while at the same
time, keeping the pre-set temperature from extreme fluctuations.
Session Timer Adjustment
1.
With sauna in the off mode (orange heater light off) repeatedly press time
button until desired session time is reached.
Setting Temperature
1.
With sauna in the off mode (orange heater light off) repeatedly press
temperature up/down button until desired temperature is reached.
a.
When heater/light on/off button is pressed sauna light will turn on.
Sauna light may be turned on or off at any time in any mode by pressing
light on/off button.
b.
Normal operating temperature is 110 F
-
125 F (43 C – 52 C).
Diagnostic Codes
SN
: Bad temperature sensor, replace temperature sensors.
OH
: Overheat, Allow sauna to cool down. No service is needed.
