THERA-Trainer THERA-fit, Инструкция по эксплуатации

Страница: 26 / 40

| 23 |
Active and Passive Training
When training actively the patient is working
against the adjustable resistance of the de-
vice by using his own physical strength, he
must operate with his own energy by doing so
(Motor resistance/Brake resistance Page 25).
Training passively means letting the patient
work without him having to use his own phys-
ical power, only by using the device. The
needed energy is being provided by the de-
vice.
THERA-fit has no motor and can only be used
for active training.
THERA-fit plus and THERA-joy have a motor.
You can train with these devices actively and
passively.
Transport and Putting into Operation
Before first Use
Take THERA-fit out and check it to see if there
are any possible damages as a result of trans-
port.
Also check and see if the line voltage shown
on the data plate has the same voltage shown
on your power cable. In the case of any dam-
age or wrong line, please call the technical
service.
Transport grip
THERA-fit and THERA-fit plus contain a
transport grip
5 . This transport grip 5 makes it
easy to carry the device. Do not lift the device
with a jerk otherwise you could damage your-
self because the device’s centre of gravity is
shifted.
THERA-joy is serial appointed with trans-
port rolls. To transport the device move it
in front of you like shown.
Power Connection (THERA-fit plus
and THERA-joy)
Plug THERA-fit plus with the power cable to
the socket. THERA-fit plus is ready, the diode
at the receiver
9 shows a yellow light.
Set On/Off the device
Press the MODE button 3 to switch on the dis-
play of the training computer 2 at THERA-fit.
THERA-fit plus: aim the remote control 8 to
the receiver 9 . Press the ON/OFF button on
your remote control 8 , to switch it on/off.
When the remote control is switched on the
diode next to the button ON/OFF is ligthed in
yellow.
Remark: THERA-fit plus contains several
safety stops. You can find those in the chapter
“Safety stop” on page 27.
F