Themis RES-32XEL, Руководство по установке

Страница: 28 / 52

RES-32XEL Installation Guide
2-4
Themis Computer
2.1.2.1 Installation
1. Remove each of the 4 Phillips screws securing the Memory-Module hold-
down bracket to the motherboard. Determine the location of the slot into
which the Memory Module will be installed (see
Figure 2-2 on page 2-5).
2. If a Module is already seated in the slot you have selected, remove it by press-
ing down and out on the latches at both ends of the slot (see
Figure 2-3 , page
2-5), then pulling the old Module directly upward until free of the connector.
3. Before inserting a new Memory Module into the vacant slot, make sure that
the two latches are pulled outward away from the center of the slot.
With the latches in the outward position, gently insert the new Module verti-
cally into its slot and press firmly downward until it snaps into place.
Bank 1 Channel A 512 MB
2 GB
Bank 1 Channel A 1 GB
6 GB
Channel B 512 MB Channel B 1 GB
Bank 2 Channel A 512 MB Bank 2 Channel A 1 GB
Channel B 512 MB Channel B 1 GB
Bank 3 Channel A Empty slot Bank 3 Channel A 1 GB
Channel B Empty slot Channel B 1 GB
Bank 1 Channel A 512 MB
3 GB
Bank 1 Channel A 2 GB
12 GB
Channel B 512 MB Channel B 2 GB
Bank 2 Channel A 512 MB Bank 2 Channel A 2 GB
Channel B 512 MB Channel B 2 GB
Bank 3 Channel A 512 MB Bank 3 Channel A 2 GB
Channel B 512 MB Channel B 2 GB
Note: For added ruggedness, in addition to socket latches, all Memory Modules
are held in place by a hold-down bracket (see Figure 1-4 , page 1-5, in Chapter 1)
secured to the motherboard by four Phillips-head screws at each corner.
Table 2-1.
Typical Memory Module Distribution (Continued)
Bank Channel RDRAM
Total
Memory
Bank Channel RDRAM
Total
Memory
Note: Make sure the Memory Module has the proper orientation by
aligning the alignment notch at the bottom edge with its slot counterpart.