Themis RES-12XR3, Руководство по установке

Страница: 55 / 146

2—Installation and Operation
Installation Procedures
2-9
Themis Computer
2.1.3.1 Installing Cards
Right PCI Riser Card: Perform the following steps to install a right-hand PCI
card:
1. Locate the slot on the riser card (see Figure 2-5 on page 2-7) within which a
card will be installed and remove the Phillips screw or tape holding the blank
I/O faceplate corresponding to the slot (see
Figure 2-8 ).
2. Remove the blank I/O faceplate corresponding to the slot.
3. Carefully install each PCI card (lower-right card first) into the appropriate slot
until all expansion cards have been installed. securing its I/O faceplate to the
rear I/O panel—if permitted—with the Phillips screw or tape removed in Step
1. Secure the side edge of each card according to the following instructions:
Figure 2-7.
… then inserted into the PCI slots of the Motherboard
Retainer Bracket
Note: Call Themis Technical Support if there is a question on how to secure the
PCI I/O faceplate to the rear I/O panel.
Figure 2-8. The RES-12XR3 has Three PCI Expansion Slots
Left PCI Expansion Slot (not used) Upper-Right PCI Expansion Slot
Lower-Right PCI Expansion Slot