Thecus 1U4200XXX, Руководство пользователя

Страница: 70 / 190

70
LAN2
LAN2 Configuration
The Thecus IP storage supports two Gigabit Ethernet ports for higher service
availability. To configure these ports, choose LAN2 from the System Network
menu, and the LAN2 Configuration screen appears. Press Apply to save your
changes.
LAN2 Configuration
Item Description
MAC Address Displays the MAC address of the LAN2 interface.
Jumbo Frame Support Enable or disable Jumbo Frame Support on the LAN2 interface.
IP Specifies the IP address of the LAN2 interface.
Netmask Specifies the Network Mask of the LAN2 interface.
Gateway
When Thecus NAS as a DHCP server from LAN2, it can have
another route to balance traffic bandwidth for its DHCP
clients
Link Detected
Specifies the LAN2 port link status
Lick Speed
Specifies the LAN2 port link speed
WARNING
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not
be able to connect to your Thecus IP Storage after Jumbo Frame is turned on. If this
happens, turn off the Thecus IP Storage. Then, insert USB disk with factory reset utility
included and power on the Thecus IP Storage. Till the system power on complete then it will
bring your system settings back to factory default.
NOTE
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your Thecus IP storage.
NOTE
If the IP sharing mode setting is set to “Enable” under WAN/LAN1 port, then this 2
nd
gateway cannot be configured.