5
Connecting a mobile device to the theSenda B/
app remote control
Open the theSenda Plug app.
Press the Bluetooth symbol in the app on the top left-hand
side.
Briefly press the Bluetooth button on the theSenda B.
▻ LED flashes red, devices are searched for.
Confirm with OK.
▻ The LED lights up red and the Bluetooth icon in the app
changes colour from grey to blue.
8. Parameters and control commands via
app
1. Parameters
Brightness setpoint value A / brightness setpoint value B
The brightness setpoint value defines the minimum required
brightness. If the prevailing brightness is below the setpoint
value, the light is switched on if presence is detected.
theSenda Plug
theSenda P
For brightness setpoint value A, you first have to press the
lighting channel 1 button on the theSenda P and the button
with the desired lux value; for brightness setpoint value B, you
first have to press the lighting channel 2 button and then the
button with the desired lux value.
Room correction factor A / room correction factor B
The room correction factor is a measurement for the diffe
-
rence of the brightness measurement on the ceiling and the
work area. The brightness value on the ceiling is influenced by
the installation location, the incidence of light, the position of
the sun, etc.
theSenda Plug
Brightness measurement value A, brightness measurement
value B
When the brightness measurement value is entered, the room
correction factor is calculated automatically and the light
measurement is adjusted to the conditions inside the room.
Follow the instructions in the app.
Swich-off delay time A+B
The swich-off delay time applies to all lighting channels.
theSenda Plug
theSenda P
Short presence A+B
If someone goes into an unoccupied room only briefly and
leaves it within 30 s, then the lighting will be switched off
prematurely after 2 min. Short presence can be used for the
fully automatic device and semi-automatic device configura
-
tion type.
theSenda Plug
