Theatrelight Nova 24, Руководство по эксплуатации

Страница: 26 / 63

NOVA OPERATION 21
SCENE RECORDING AND PLAYBACK
Scene levels may be recorded into any Scenemaster, even those marked "Shows":
RECORDING AND ASSIGNING A SCENE
You should always make sure the Record LED is GREEN before recording any new levels: if it is Red or flashing Red, the Record
Buffer needs to be cleared:
> Hold [RECORD] then press [DBO]: after a Mimic flash the Record LED will change to Green.
The Record Buffer is now clear for recording new levels:
1 Set the Channels Master at Full, and set up levels on the Channel faders.
2 Press and release [RECORD].This records the output of the desk in spare memory; the Record LED turns Red.
3 Hold [RECORD] and press a Scenemaster Flash key to assign the recording to that fader on the current
page.
After a short Mimic flash the Record LED turns Green the Record Buffer memory is now empty, and the Scene is recorded under
the Scenemaster fader. The LED above the Scenemaster is set On to show a Scene has been recorded. A Scene may be
assigned to any Scenemaster, including those marked "Shows".
SCENE PLAYBACK
With the Fade Master set at Instant, raising the fader level of a recorded Scene brings up the levels of that scene at the same
speed as you move the fader. Scenes add levels on a highest takes precedence basis. Channels live are shown on the Mimic
LEDs.
FLASHING SCENES
Pressing the Flash key of a Scene instantly recalls the levels of that scene. A flashed Scene adds levels on a latest takes
precedence basis flashed levels over 5% over-ride any other output level. This mode of operation is useful for turning some
channels effectively off (flashed scene levels recorded at 5%), while others are turned on. Pressing a Scenes Flash key at the
same time as the DBO key blacks out all other output, leaving only the flashed Scene levels.
RECORDING A SCENE BLIND
Scenes can also be recorded blind (without showing on stage) from the Channel faders as follows:
1 Set the Channels Master Off, and set up some levels on the Channel faders.
2 Hold [RECORD] and press the [CHANNELS] key above the Channels Master to record the Channel fader levels.
This Blind Scene can now be assigned to a Scenemaster for playback as described above.