6
Step 7: Assembling & Inserting Mid Bar and Bottom Bar
Mid Bar
Join the middle bars[20] together by sliding the outer rods over the preinstalled joiner[21]
section.
(SEE DETAIL G)
Use the 1/2 Phillip screws[23] , fasten the screws in the pre marked holes to connect the
rods together.
Insert the assembled middle bar through the pocket at the center of the screen.
Fit the middle bar end caps Velcro[22] into both ends of the middle bar. You may need to
gently tap with a hammer.
(SEE DETAIL F)
Bottom Bar
Join the bottom bar sections[17] together by sliding the bottom bar joiner[18] into the
other bottom bar(s) using a hammer.
(SEE DETAIL E)
Note: This is a jam fit and may require hitting the bar against a solid surface or wall. We
suggest putting a piece of wood between the surface and the tube to avoid damaging
the surface .
Insert the assembled bottom bar through the pocket at the bottom of the screen.
Using a hammer, tap the bottom bar end caps[19] onto both sides of the bottom bar
. (SEE
DETAIL C)
Step 8: Setting Your Upper and Lower Limits
WE STRONGLY ADVISE WATCHING OUR INSTRUCTIONAL VEDIOS AT
WWW.THESPORTSCREEN.COM/INSTRUCTIONAL-VEDIOS BEFORE YOU SETTING YOUR LIMITS
The li it
sets how high or low The SportScreen will roll when activated by the remote(s). There is an
adjusting screw on either side of the power cord.
