10/2021 V 1.1
VIEW 31DW
Fixing Holes
Drill 1 side only
Fixing Holes
Slider Bar Insert
x - 15mm
x - 15mm
10/16
Measure the distance from the wall to
the nearest fixing hole on the Inline
Panel. Ensure this measurement is truly
horizontal.
Subtract 15mm to get your final
dimension.
With masking tape applied, place the
supplied Slider Bar Jig firmly at the
trimmed end of the Stay Bar and mark
the hole with a pen.
Drill holes using a 5mm drill bit.
Insert the Slider Bar Insert into the
Slider Bar and ensure that the threaded
holes in the Slider Bar Insert align with
the clearance holes on the Slider Bar.
Mark the final dimension on the Slider
Bar on the opposite side of the Slider
Bar.
Cut squarely using a chop saw and
finish the edge.
SLIDER BAR IS STAINLESS STEEL
37
38
39
40
