10/2021 V 1.1
VIEW 31DW
04/16
Using purpose built "Glass Li�ers",
posi�on and sit the Return Glass Panel
on to the Underframe Gasket and push
against the Wall Profile.
Note the orienta�on and posi�on of
the Panel, this can be determined by
any holes or a�ached labels.
Remove and replace the Panel adding
or subtrac�ng spacers as necessary to
level the Panel (to a maximum height
of 5mm inside the Underframe).
Check the Panel is level using a Spirit
Level.
Align the Return Panel so there is a
4mm gap between the Panel and the
front face of the Front Underframe.
If the Wall Profile IS flush with the
Glass Panel, move on to step 20.
If the Wall Profile IS not flush with the
top of the Glass Panel, mark the Wall
Profile. Using a straight edge, mark
where the wall channel needs to be
trimmed.
To protect the channel finish, it is
recommended to mark on masking
tape.
13
14
15
16
4mm
