03/2021 V 1.0
VIEW 09
18/20
Attach the Glass to Glass Hinges to the
door and tighten.
Evenly tighten the screws until the
gaskets are just “nipped”.
Tighten all screws to 15.6N.
DO NOT fit the Cover Plates yet.
Measure the width of the door (glass
width). Cut the bottom door seal
accordingly.
Trim the outside edges on both ends to
allow the two vertical seals to touch
the glass.
Attach the Seal ensuring the Seal is
correctly oriented.
Push both Vertical Seals down as far as
they can go.
With a straight edge, mark where the
Seals will be trimmed. Remove the
Seals and trim with a fine toothed
junior hacksaw so they are flush with
the tops of the Glass Panels.
Replace the seals.
Outside of
enclosure
37
38
39
40
