03/2021 V 1.0
VIEW 09
05/20
If the Wall Profiles are flush with the
Glass Panels, move on to step 20.
If the Wall Profiles are not flush with
the top of the Glass Panels, mark the
Wall Profile. Using a straight edge,
mark where the wall channel needs to
be trimmed.
To protect the channel finish, it is
recommended to mark on masking
tape.
Remove the Panels, Wall Profile Soft
Seals, and the Wall Profiles.
Trim the Wall Profile.
Use a fine file to remove any burrs. Be
careful not to damage the channel
finish.
Re drill the screws in to the Wall Profile
and remove after drilling.
Reinstall the Wall Profiles, Wall Profile
Soft Seals, and Glass Panels.
Measure the width of the Door. Add
12mm to this dimension. This is your
door gap. Adjust the Inline Panel to
achieve the door gap.
To centre the panel, add 1mm Packers
on both sides of Inline Panel and
Return Panel in the Underframe.
WARNING
The glass is heavy and may
damage the
fl
oor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
x
17
18
19
20
