Outside of
enclosure
03/2021 V 1.0
VIEW 09
Cover Plate
Clamping
Plate
x
16/20
Measure the distance between the
Inline Panel and the inside face (wet
side) of the Return Panel.
Mark and cut the Underframe Top.
Snap the Underframe Top on to the
Underframe.
Remove Return Panel Packers and feed
the Underframe Wedge Gasket into the
archway gap of the Return Panel and
trace along the Glass on both sides.
Spray water on Glass Panel and use
Nylon Block to help feed Gasket. Trim
the Wedge Gasket where it meets the
Underframe Top.
Attach the Glass to Glass Hinges in the
direction your door will open and
tighten to the Inline Panel.
Evenly tighten the screws until the
Gaskets are just “nipping” the Glass.
Tighten all the screws to 15.6N.
Check the orientation of the Cover
Plates. Adjust Clamping Plate to Suit.
DO NOT fit the Cover Plates yet.
29
30
31
32
