Place spacers into the base channel
evenly, as shown below. Begin with the
4mm spacers.
NOTE: There must always be a
minimum set of 1mm spacers used
under the glass panel.
Loosely assemble the 90° glass to wall
brackets onto the panel. The
face that a�aches to the wall should be
located inside the enclosure.
DO NOT fit the cover plates.
5
6
7
8
Note the orienta�on and posi�on of
the panel, this can be determined by
the number and size of holes and any
a�ached labels.
Using purpose made “Glass Li�ers”,
squarely insert the panel into the wall
channel and lower onto the spacers.
Take great care NOT to
knock the corners as this can cause the
panel to sha�er.
Remove and replace the panel adding
or subtrac�ng spacers as necessary to
level the panel (to a maximum height
of 14mm inside the base channel).
Check the panel is level using a Spirit
Level.
02/12
4mm
4mm
WARNING
The glass is heavy and may
damage the floor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
View 01
07/2019 V 2.2
