17
18
19
20
It is very important to put a good
amount of silicone in the corner where
the wall channel meets the base
channel. This area needs to be properly
sealed to prevent any water leakage.
Check the spacers are s�ll in their
original posi�on.
Carefully lower the glass panel back
into the wall channel and onto the
spacers.
Screw the brackets to the wall.
Evenly �ghten the screws un�l the
gaskets just “nipping” the glass.
Tighten all glass screws to 15.6N.
DO NOT fit the cover plates.
05/12
Check which stay bar configura�on
your screen has been supplied with and
refer to the relevant instruc�ons below.
(You can find this out at the front of
these instruc�ons).
WARNING
The glass is heavy and may
damage the floor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
Config A - SB1
Page 06
Config B - SB2
Page 09
View 01
07/2019 V 2.2
