Installation & Operation Manual
3.
Insert an anchor into each of the 2 holes using a hammer.
4.
Insert a screw into each anchor leaving a 1/16-1/8 inch gap between the head of the screw and the mounting
surface.
5.
Connect the network cable to the back of the clock.
6.
Place the keyhole slots on the back of the clock over the screws and secure it into place.
2.3.2 Rack Mounting
1.
Attach an ear to each side of the clock.
2.
Attach clock to rack.
ILLUSTRATION: Attaching Rack Mounting Ears
2.3.3 Dual Clock Mount Bracket
Materials Needed:
1.
Two Time Machines clocks of the same size
2.
One Dual Mounting Bracket (760-265-000, 760-445-000 or 760-465-000)
3.
3/4” pipe, elbows, flange. Depending upon how you want to mount the clock determines what pipe lengths and
fittings you will need. The Dual Mounting Bracket accepts any 3/4” tubing with NPT (National Pipe Threads)
threads on the ends. This product is available through local hardware stores or large national chain stores.
4.
Make sure that the power supply cord is long enough to reach the clock and wall outlet.
How to mount two clocks in the dual mount bracket:
1.
Take two Time Machines clocks and match where the notch is on the display cover – this is where the Ethernet
cables will enter into the clock displays. The Dual Mount Bracket can be placed on the bottom or on the top of the
clocks. If needed, the display can be inverted so that the cables can run through the bracket and down into the
backside of each clock.
2.
At the ends of the clocks, leave the screws out about ¼” so that they can be inserted into the key holes on the
Dual Mount Bracket.
3.
BEFORE you mount the clocks into the bracket, run two Ethernet cables through all pipes and fittings that will be
used to hang the clocks. Connect the cables to the clocks and then mount the clocks into the bracket.
4.
Secure the bracket to the clocks by tightening the screws on the ends of the bracket into the clock.
5.
Begin to tighten the pipe into the bracket. Start from the pipe/Dual Clock Bracket connection out to the
connections for the wall or ceiling.
6.
Secure the entire fixture to the wall or ceiling.
7.
Connect the Ethernet cables.
[ 2 ]
Time Machines by CSS | 6030 South 58th St., Suite C | Lincoln NE 68516
voice: 402.261.8688 | email: [email protected] | web: css-timemachines.com
