25
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
Automatic Clean Mode.
5.
Allow 30 minutes for proper cleaning. After cleaning, shut off the power
switch, and unscrew the nut of the water-draining hole. Drain off the waste
water to some container, and then screw the nut on tightly when the waste
water is fully drained off.
6.
Repeat steps 4 and 5
(without Ice Maker Cleaning Solution)
to rinse the
ice making system 3 times.
Note: The use of the Ice Maker Cleaner Solution in the water bin during the rinse is
not needed.
7.
Prepare a sanitizing solution made of 1oz (29ml) of household bleach and
2 gallons (7.5L) of hot water 95ºF (35°C) to 115ºF (46°C). Remove the
flake covers and slideway from the water bin and wipe the entire bin
inside and out, covering all surfaces.
8.
Fill a spray bottle with the sanitizing solution and spray all corners and
edges making sure to cover all surfaces with the solution. Soak the flake
cover and slideway in the solution and put back in place after drying.
9.
Allow the solution to be in contact for at least 3 minutes, and then dry.
10.
Repeat step 6 to rinse the ice making system one more time.
11.
Reassemble the front cover.
12.
Turn on the power. The machine will return to the normal ice making
operation. Discard the first batch of ice.
Control Box
(See diagram on page 30.)
Instructions for LEDs and buttons:
1.
RED LED:
Ice full indicator light.
When this LED is lit, the ice storage bin is full of ice and the unit will stop
working. When ice cubes are taken out of the ice storage bin, clearing the
sensor, the red LED will flash for 3 minutes. Then the unit will restart and
return to the ice making mode.
