The Handy 1938139001, Инструкция по эксплуатации

Страница: 13 / 24

Before initial operation, check that the two-handed operation is properly functioning by following
these steps:
a)
Lower both control levers, the wedge should lower to approx. 5cm above the table at the
highest position.
b) Release either of the levers, the wedge should remain in its original position.
c) Release both levers, the ram should rise to the highest position automatically.
To set the wedge ram stroke, follow the steps below:
a)
Move the wedge to the desired position. The upper position of the ram wedge travel should be
about 3-5cm over the logs to be split.
b) Release one control lever or switch off the motor.
c) Release the Setscrew (A). Raise the Adjusting Rod (B) until you reach your desired position.
Tighten the Setscrew (A).
d) Release both control levers or switch on the motor.
e) Check the upper position of the wedge.
•
Place the log onto the support table vertically so that it is flat on the support table. Ensure the
wedge and support table will contact the log squarely on both ends.
Never attempt to split a logs at an angle.
Break log in the direction of its growing grain. Do not place log across the log splitter for splitting.
It may be dangerous and may seriously damage the machine.
•
Hold the log closely with the clamping brackets in the control lever guards. Lower the levers to
start splitting. Releasing either lever will stop the motion of the wedge. Releasing both handles
will return the wedge to the upper position.
•
Stack as you work. This will provide a safer work area, by keeping it uncluttered, and avoid the
danger of tripping, or damaging the power cord.
WARNING
Accumulated split wood and wood chips can create a hazardous work environment. Never
continue to work in a cluttered work area which may cause you to slip, trip or fall.