The Handy 1938138001, Инструкция по эксплуатации

Страница: 4 / 20

SPECIFICATION
The manufacturer reserves the right to change the product specification and livery according to
continued product improvements.
Model THLSV6
Product No. 1938138001
Motor Rated Power 230V~ 50Hz - 2700W - S6 - 40% - IP54
Log Size Capacity
Diameter Min. 13cm - Max. 30cm
Length 107cm - 81.5cm - 56cm
Maximum Force 6 Ton
Hydraulic Pressure 24 Mpa
Hydraulic Oil Capacity 4 Litres
Ram Travel 495 mm
Forward Speed 3.6 cm / sec.
Retract Speed 19 cm / sec.
Sound Power Level (L
WA)
88.2 dB (A) under no load; 89.7 dB (A) under full load
Overall Size
Length 90cm
Width 119cm
Height 149cm
Weight 97kg
* S6 %40, continuous operation periodic duty: time of one load cycle is 10 minutes, operation time at
constant load is 4 minutes, operation time at no-load is 6 minutes.
* The diameter of the log is not the only factor that determines how easy it will be to split. A small log can
be difficult to split when it has knots or is a particularly hard wood.
IMPORTANT INFORMATION
HYDRAULIC OIL
This machine is supplied with Hydraulic oil from the factory, to allow the machine to be used straight from
the carton. Do check the oil level (instructions available in the manual) prior to the first use and
periodically thereafter.
ELECTRICAL REQUIREMENTS
With 230 Volt / 50Hz motor, the log splitter should be connected to standard 230V+10% / 50Hz+1Hz.
Electrical supply which has protection devices for under-voltage, over-voltage, over- current (16 A) as well
as a residual current device (RCD) with maximum residual current rated at 0.03A. Electrical connection
rubber cables must comply with EN60245 which are always marked with symbol H 07 RN. Cables should
be identified, as it is a legal requirement.
EXTENSIONS LEADS
Improper use of extension leads may cause inefficient operation of the log splitter which can result in
overheating. Be sure the extension lead is no longer than 10m and its cross-section is no less than 2.5mm²
to allow sufficient current flow to the motor. Avoid use of loose or inadequately insulated connections.
Connections must be made with a protected material suitable for outdoor use.
WORKING CONDITIONS
This log splitter is a domestic use model. It is designed for operating under ambient temperatures between
+5
o
C and 40
o
C and for installation at altitudes no more than 1000m above M.S.L. The surrounding
humidity should be less than 50% at 40
o
C. It can be stored or transported under ambient temperatures
between -25
o
C and 55
o
C.
INSPECT YOUR LOG
Make sure there are no nails or foreign objects in logs to be split. The ends of the logs must be cut
square. Branches must be cut off entirely so that the trunk is relatively smooth.