THE GILBERT HALL American Flyer, Инструкция по эксплуатации и сборке

Страница: 35 / 66

OPERATING THE
NO. 592A
CROSSING GATE
The No. 592A Crossing Gate is operated by a pressure type track trip
No. 697. See information on attaching and adjusting the No. 697 Track Trip
on page 3 3 . Study Figure 29 and connect as follows:
Connect wire
“A”
from one of the terminal posts on the Crossing Gate
to the base post terminal on the transformer.
Connect wire
“B”
from the Crossing Gate to number three terminal
on the Track Trip.
Connect wire
“C”
from the number one terminal clip on the track
trip to the 1 5 volt post on the transformer.
The gate is now ready to operate
-
when the train crosses the portion
of track to which the track trip is attached
-
the gate-arms will go down
and the red lantern will light.
INSTRUCTIONS FOR SETTING UP AND
OPERATING
NO.
760 HIGHWAY FLASHER
T o hook up the No. 760 Highway Flasher, first determine the approxi-
mate location in your layout where you wish it to operate; then attach the two
No. 696 Track Trips
t o
the track one on each side of the highway which is to
be protected, and have the trips about
2
feet apart. T o do this, first place the
trips under the track so that lower flange on one rail nests under the raised
portion
of
the metal strip with the
“U”
shaped cutout and the locking lever
locks on the same rail as that to which the
BASE
POST
wire connects. Note
Fig.
30.
34