THE GILBERT HALL American Flyer, Инструкция по эксплуатации и сборке

Страница: 16 / 66

When attaching No.
690
Track Terminal to
a
section of track, put
shoulder shown as
“A”
against bottom of outside rail as in Fig. 9. Press
spring shown at “B” up and around bottom of other rail as in Fig. 10. Take
wires shown as “C” and “D” in Fig.
11,
cut off about of insulation from
each end of wire. Connect
BLACK
wire from clip marked
BASE POST
on the track terminal to the
BASE POST
on the transformer. Connect the
WHITE
wire from the remaining terminal clip to the
7-15 VOLT POST
on the transformer as shown in Fig. 1 2 , below. If the terminal is used to
supply track current to a piece of equipment, the wires “C” and “D” are
connected to the two terminals on the equipment unless equipment instruc-
tions read otherwise.
When wiring the air chime whistle control
unit, do not use this wire from
7-1 5 Volt Post,
but
follow
the wiring diagram on
page
53.
15