These components must be installed before installing
Ventilated Shelves.
Place Hanging Standards
– Hanging Standards should be positioned using the elfa Spacer provided
in the package
(Figure F)
according to your design.
Classic Hanging Drawers,
décor Drawers and
Gliding Accessory Racks
Install Stabilization Bar
–
Secure the Stabilization Bar by tapping both ends into the top of the
two Uprights with a plastic mallet.
(Figure A)
–
Alternate tapping left and right ends until both are locked
into place.
–
Add End Caps (included) at the top of the Uprights for a finished
appearance.
(Figure B)
If assembling 4' or wider solution, repeat above Steps 1, 2 and 3
as necessary. After all of the sections are added, place End Caps
and Center Caps (included) at the top of the Uprights for a finished
appearance. (Figure B, Figure C)
Attach a Ventilated
Shelf to the Feet
– Lay the Ventilated Shelf across the span between the Feet.
The support wires should run along the bottom of the Shelf.
–
Place the last Shelf wire over the middle of each Foot.
(Figure D)
–
Start at the back of the Shelf. Slip the Shelf Clip over the last
Shelf wire; it will snap into the notches on both sides of the Foot.
–
Repeat for all four corners of the Shelf.
(Figure E)
–
If your design calls for two Shelves to share one Foot, begin by
attaching the clips at the joined Shelves first, then clip the
opposite ends of both Shelves.
Refer to your design for placement of the elfa Brackets on
the freestanding Uprights.
Once you’ve added all elfa components, adjust levelers as
needed with the wrench included with the Feet.
A
B
C
D
E
F
STEP
3
STEP
4
STEP
1
8
Visit
containerstore.com/installation
to view video instructions.
