8
3. Blinking green (module status) light
(a) Slow and continual blinking
(b) The battery connected to the WiFi module is low
on voltage
4. Rapid blinking green (module status) light
(a) The module is in the process of sending a message
Note: About 8 quick blinks
5. Solid red (connection error) light
(a) The module is not connected to the Wi-Fi network
(b) Check your Wi-Fi router
6. Blinking red (connection error) light
(a) The module is not communicating with the server
properly
(11) Resetting the module & Troubleshooting
This section will explain how to clear the module if it is
changing ownership.
1. If the module is changing hands or you are moving
and leaving it for the new homeowners, you do not
want to receive notifications from a unit that is no
longer yours.
(a) Using a paperclip, press and hold the reset button
on the WiFi module for approximately 5 seconds.
(b) This will cause the LED’s to alternate again. Leave
it in this mode.
(c) The next user will register the module to their email
address.
Warning
Changes or modifications not expressly approved by
Glentronics could void the user’s authority to operate
the equipment.
Troubleshooting
This section will explain how to troubleshoot any problems
Problem
Red light is on steady
The red/green lights
keep alternating after
the setup process
Green light is steady,
red light is flashing
During set up, if red
and green lights are
on steady and not
alternating
Solution
Check your router and internet
connection. Then, power cycle
the module. Unplug the module
from the wall and disconnect
from the battery. Let it sit for
a minute then reconnect both
power sources.
Press the reset button with a
paper clip and restart the setup
process
Communication error. Power cycle
the module. Unplug the module
from the wall and disconnect
from the battery. Let it sit for
a minute then reconnect both
power sources. If red light is
still flashing in 24 hours, call
Glentronics support
Reset the WiFi module by
pressing the ‘reset’ button with
a paperclip for 5 seconds and
restart the setup process.
