Thames & Kosmos Remote Control Machines, Инструкция

Страница: 12 / 48

12
REMOTE-CONTROL MACHINES
| Model 2 Three-Wheeler
Size (cm) : 22 (L) x 21 (W) x 11 (H)
Draw a square or put a sheet of paper on
the ground to form a parking spot. Try to
control the car to move it backward, and
see if you can park it perfectly inside the
lines of the parking area.
1 2
3
4
●
The red gears on driving axle must keep
1 mm away from the curved elbow rod
so that they can turn smoothly.
●
Use the end of the part separator tool
marked with "A" to pry up the pin.
●
If the motor doesn’t work, check to
make sure the wire connector of the motor and the output of the receiver/battery holder are
well connected, or that the batteries are not dead.
1
3
4
6
1
3
4
6
3
1
+
6
4
+
How to Operate
：
1. Turn on the switch
on the remote
controller.
2. Touch the touch
pad
1
or
4
on the
remote controller
to activate the
motor connected
to its corresponding output (the one on the left) on the receiver/battery holder, and the
three-wheeler will turn counterclockwise or clockwise.
3. Touch the touch pad 3 or 6 on the remote controller to activate the motor connected to
its corresponding output (the one on the right) on the receiver/battery holder, and the three-
wheeler will turn clockwise or counterclockwise.
4. Touch two touch pads
1
and
6
(or
3
and
4
) on the remote controller at the same time,
and the three-wheeler will keep turning around.
Challenge
：
Park the three-
wheeler in a certain
area backward
with the remote
controller.
Tips for Assembly
：
555004 Booklet Final 2015.indd 12 9/21/15 10:17 AM