Connecting to the Appliance
This section provides the following procedures for:
>
"Connecting the appliance to your network" below
>
"Connecting the appliance to a console device " on the next page
>
"Connecting to the GUI" on page 20
Connecting the appliance to your network
Follow these instructions to connect and begin configuring the appliance.
To connect your appliance to your network:
1.
Insert the power (a) and network (b) cables at the rear panel.
NOTE
The physical location of the network ports (Eth0, Eth1, Eth2 and Eth3) are
dependent on the appliance model. Correct locations for your model are printed on the
rear panel.
For proper redundancy and best reliability, the power cables should connect to two completely independent
power sources.
2.
Press and release the Start/Stop switch on the front panel to power up the appliance.
KeySecure k470 Appliance : Installation Guide
16 June 2020, Copyright © 2020 Thales Group. All rights reserved.
18
