
82
Promark2 User’s Guide
The
Point Attribute
screen lets you enter attribute information for the survey point
you are about to observe. The attribute information comprises the following
parameters:
• A 4-character site ID. You must assign a site ID to each point surveyed in your
project.
• A site occupation timer that counts down in seconds.
• An optional 20-character narrative description of this point.
• An optional initialization setting; either no initialization, a known point or an
initializer bar point.
• An optional control point setting. Set to <Yes> if the point is a control point. The
site ID is copied to the known site ID table.
A unique aspect and an absolutely essential step for a successful stop-and-go survey
is the initialization process. The stop-and-go rover must be initialized prior to
surveying any points. The initialization can be an observation on the initialization
bar, a known point, or a new point. The following example is an initialization using
the initialization bar.
From the
Point Attribute
screen, highlight
Initialize
and press
ENTER
to bring up
the
Init Mode
Highlight
Bar
and select
Save
. The
Point Attribute
screen will be shown (Figure
Figure 3.45
Init Mode Screen
Содержание CGRS
